HP Power Protector 1.02.28 and connection loss (248 Views)
Reply
Occasional Visitor
Lurchi123456789
Posts: 1
Registered: ‎12-06-2013
Message 1 of 1 (248 Views)

HP Power Protector 1.02.28 and connection loss

Hello,

 

in HPPP I configured a power source with two R5000 UPS over network interface lwith latest Firmware) . Everything is fine for 2 minutes, but then HPPP looses the connection to the two UPS. And there is no way to connect them again. Only possibility is to delete the power configuration an d configure it again. But after 2 minutes the same problem.

 

Does someone know the problem?

 

Thanks!

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation