02-27-2006 09:53 AM
There's not a password to access the S/W once installed either.
Are you sure you're not asking for a password for some device that LTT might want to talk to - like a tape library or NSR?
02-27-2006 11:48 AM
read of lvm record failed. There is an advisory out:
This issue is the result of a new process being implemented with optical media (specifically 30G UDO Rewriteable media) by which the media is pre-formatted at the factory with an erase pattern. The result is that every logical block on the surface is written as "blank."
This creates an issue for the HP-UX file systems (vxfs and hfs) because part of the format process is to perform a read on the disk. These blanks cause the drive to report a check condition in response to the read which is the correct behavior. This response however was not considered when developing file system support as previously all R/W media was sent out with a written pattern on it and reads would always return some date, therefore the calls to mkfs fail, giving the message vxfs mkfs: read of lvm record failed .
The solution to this issue is to set the corresponding mode page to disable blank check reporting. This can be done using the UDO Blank Off Config Test in Library and Tape Tools.
02-27-2006 02:45 PM
Yes, there is "special password" required for changing those kind of settings in LTT.
I don't know the password but I guess you can send an email to HP LTT Team at
email@example.com asking to guide you with the required change.