Conversion to hardware Raid 5 (184 Views)
Reply
Occasional Contributor
Charlie Ruble
Posts: 2
Registered: ‎07-09-2002
Message 1 of 2 (184 Views)

Conversion to hardware Raid 5

We have a E60 running NT with one drive. We have a netraid controller #P3410A that we will install. If I put the existing drive on the controller I assume it will boot up fine. Next, I'd like to add the other 2 drives to the controller and convert it to Raid 5. Will the software do this or must I convert it, then restore from backup? Any suggestions are appreciated.
Respected Contributor
BR642007
Posts: 124
Registered: ‎11-05-2001
Message 2 of 2 (184 Views)

Re: Conversion to hardware Raid 5

Hi Charlie,

This is what you should do:

1: Install the correct Netraid driver first.
2: Create a full backup!
3: Built in the Netraid and connect the disks to it.
4: powerup the server and Enter Netraid Express-Tools with Ctrl-M
5: Create a RAID0 logical drive on the original disk with NT on it( remember it's SCSI ID). Do not do anything with the 2 other drives. DO NOT INITIALIZE, it will destroy your data.
6: Reboot the server. NT must boot fine.
7: Install netraid assistant from Navigator or download it from the web.
8: Start Netraid assistant
9: Drag 'n drop the 2 new disks to the existing logical drive and add them, select the new RAID level (RAID5) and let the netraid do it's work in migrating your data.
10: You have extra capacity available now you can configure in Netraid assistant.

Good luck,

Marco.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.