Re: "evaperf hps" has all zeroes for half the ports (248 Views)
Reply
Regular Advisor
Jeremy C
Posts: 173
Registered: ‎11-21-2006
Message 1 of 2 (248 Views)
Accepted Solution

"evaperf hps" has all zeroes for half the ports

All evaperf commands produce good results except for "evaperf hps". It worked fine until I changed the zoning to make ports FP3 and FP4 dedicated CA ports. Now I get all zeroes for the hps stats for those ports.

Any ideas?

EVA 8100 (two of them)
Command View EVA 9.2
RSM 5.1
Please use plain text.
Trusted Contributor
susanta_dutta
Posts: 82
Registered: ‎11-19-2009
Message 2 of 2 (248 Views)

Re: "evaperf hps" has all zeroes for half the ports

Hi Jeremy,

You are getting all zeros because, The HPS object provides information about performance and data flow of host-initiated activity on each array host port. Data replication traffic is not included in these counters.

This is mentioned under "HP EVA host port statistics" section in Command View User Guide, available at:
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c02010669/c02010669.pdf

You may use "EVAPerf drt" to get Data replication traffic & performance data.

Regards
Susanta
Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation