Re: SA P400 Array Accelerator Batteries Failed to Charge (3247 Views)
Reply
Advisor
PAUL FARINELLI
Posts: 42
Registered: ‎07-29-1998
Message 1 of 3 (3,247 Views)
Accepted Solution

SA P400 Array Accelerator Batteries Failed to Charge

[ Edited ]

Is it safe to proceed after getting these messages when booting HP-UX 11iV3 on an rx6600?

HP Smart Array P400 Controller (version 5.20) 1 Logical Drive

1794-Drive Array - Array Accelerator Battery Charge Low

Array Accelerator Posted-Write Cache is temporarily disabled.

Array Accelerator batteries have failed to charge and should be replaced

 

 

P.S. This thread has been moevd from Disk to Disk Array. - Hp forum Moderator

Honored Contributor
marsh_1
Posts: 986
Registered: ‎03-25-2004
Message 2 of 3 (3,247 Views)

Re: SA P400 Array Accelerator Batteries Failed to Charge

paul,



have a look here at number 1794 , i'd get them replaced asap :-

http://docs.hp.com/en/J6369-90072/apcs01.html

good luck

Honored Contributor
Honored Contributor
cnb
Posts: 1,197
Registered: ‎09-18-2008
Message 3 of 3 (3,247 Views)

Re: SA P400 Array Accelerator Batteries Failed to Charge

Hi Paul,

Yes, but there are operational cautions that you need to be aware of until they are replaced.

http://docs.hp.com/en/J6369-90072/ch01s03.html

http://h18004.www1.hp.com/products/quickspecs/12400_div/12400_div.pdf

405835-001 512MB battery backed write cache (BBWC) memory board - 72-bit, DDR - For Smart Array P400 controller

-or-

405836-001 256MB battery backed write cache (BBWC) memory board - 40-bit, DDR - For Smart Array P400 controller


HTH,
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.