Re: Continious Access setup (123 Views)
Reply
Super Advisor
inex
Posts: 282
Registered: ‎05-24-2005
Message 1 of 4 (123 Views)
Accepted Solution

Continious Access setup

Hi,
I have connected an EVA4400 and EVA6400 through Brocade switches. I have zoned the EVA ports together. EVA6400 port 2 and 4 on both controllers with port 1 and 2 on the EVA4400. In CV under view remote connections, there is no no paths. We have CV 9.2. So far I have not set the aptpolicy. Any ideas why they can't set up paths between the EVA's.

-inex
Trusted Contributor
Bulent ILIMAN
Posts: 102
Registered: ‎11-06-2009
Message 2 of 4 (123 Views)

Re: Continious Access setup

do you have Cont.Acc license for both EVAs?

and what are the XCS Versions?
Trusted Contributor
susanta_dutta
Posts: 82
Registered: ‎11-19-2009
Message 3 of 4 (123 Views)

Re: Continious Access setup

Hi inex,

By any chance , are you running 09534000 on any array

If an Array is initialized with XCS 09534000 or later, Exchange-based routing option is set by default. In order to create any Data Replication(DR) relation with an Array running lower than XCS 09534000, set Data Replication Protocol to â HP FC Data Replication Protocolâ from Data Replication > Data Replication Option > Set Data Replication Protocol option.

Refer latest CA Implementation Guide at hp.com/go/caeva for more information on this.

Regards
Susanta
Super Advisor
inex
Posts: 282
Registered: ‎05-24-2005
Message 4 of 4 (123 Views)

Re: Continious Access setup

Both EVA's have xcs 09534000 version
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.