Re: HP DSS (OCR) Software - Specifying FTP Port Numbers (6850 Views)
Reply
Occasional Visitor
mssmith_skopos
Posts: 1
Registered: ‎06-04-2013
Message 1 of 2 (6,892 Views)

HP DSS (OCR) Software - Specifying FTP Port Numbers

[ Edited ]

Is there any way possible to specify an FTP port number with this software? It doesn't seem to accept anything I put in. I'm assuming it only uses port 21 but I need to send it using another port. This would be when using work flows or sending to a network folder. This has been a major pain for us. Any help would be appreciated.

HP Pro
Soups_on
Posts: 19
Registered: ‎05-06-2013
Message 2 of 2 (6,850 Views)

Re: HP DSS (OCR) Software - Specifying FTP Port Numbers

You are correct that the Send to FTP only uses port 21 and there is not anyway to change the port number.

 

However, you might try adding a device QuickSet to send to FTP folder.  You can specify the port number there.  You will probably have to remove the device from DSS, set up the QuickSet, then add the device back to DSS.

 

good luck,

 

I work for HP. The views expressed in my contributions are my own and do not necessarily reflect the views and strategy of HP.

Say Thanks by clicking the Kudos Star in the post if this helped you.
Please mark the post that solves your problem as Accepted Solution
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.