Re: Error message: Cannot connect to CM (179 Views)
Reply
Super Advisor
Yaboto
Posts: 453
Registered: ‎02-07-2007
Message 1 of 2 (193 Views)

Error message: Cannot connect to CM

Hi,

 

DP 8.0 is running on HP-UX on vPAR 6.0 on Integrity BL890 ic4 npaR. I installed UI on a Windows7 PC. When connecting i get the following error message below and as attached:

 

"Connection to CRS failed.

To start the DP daemons on the CM host use the command omnisv -start on the CM

or check if the communication between the CM and client is encrypted with the command

omnicc -encryption -status  -all on the CM".

 

I did all what i could by disabling encryption and by allowing access from ANY to ANY, but still i could not connect.

Please help!

 

Yaboto.

 

Honored Contributor
Sebastian.Koehler
Posts: 1,157
Registered: ‎02-27-2007
Message 2 of 2 (179 Views)

Re: Error message: Cannot connect to CM

Is your client able to resolve the CM FQDN properly and are you running a DP A.08.00 GUI? Have you added an entry to the /etc/opt/omni/server/users/UserList for your client and user?

 

Point a web browser to the following site https://<cm-hostname>:7116


It will ask whether it is allowed to continue, then a click on the certificate symbol just before or after the address bar, will show you the certificate. This way you can see whether the certificate is expired

 

Regards,

Sebastian

---
Assign a kudo to this post, if you find it useful.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.