Data Protector - Support Tip - Error when backing up large Hyper-V installati​ons (288 Views)
Reply
HP Expert
Bob_Clark
Posts: 1,423
Registered: ‎08-14-2013
Message 1 of 1 (288 Views)

Data Protector - Support Tip - Error when backing up large Hyper-V installati​ons

Hyper-V VEA backup of VMs on cluster shared volumes (CSV)

---------------

During Data Protector VEA backups often messages were observed like the following, especially if several VMs were involved in the backup. Smaller backups of say 5 VM were running fine.


Only if larger number of VMs were involved and these were distributed over several CSV and were accessed via different Hyper-V server the issue could be observed

.

Error in session report
-->
[Major] From: OB2BAR_VSSBAR@system.domain "HyperV" Time: 11.10.2012 16:13:52
Cannot perform backup of:
'/Microsoft Hyper-V VSS Writer/Virtual Machines/Backup Using Child Partition Snapshot\VSAP-BHS301',
which contains data in:
C:\ClusterStorage\Volume2\VSAP-BHS301\Virtual Machines\7B36324F-E064-4948-AA14-D189EBC32673.xml
C:\ClusterStorage\Volume2\VSAP-BHS301\Virtual Machines\7B36324F-E064-4948-AA14-D189EBC32673\*
C:\ClusterStorage\Volume2\VSAP-BHS301\VSAP-BHS301_disk_1.vhd
C:\ClusterStorage\volume2\vsap-bhs301\vsap-bhs301_disk_2.vhd

 

There are two parameters that can help with the problem.

'omnirc' local environment variable:

           OB2VSS_TIMEOUT
----------------
The timeout has to be set on the Hyper-V servers where vssbar is running (not on the VEAgent host) and that it's long enough. The default is 180 min

---------------

'global' environment variable:

CellResourceTimeout
Default is 7200 seconds (2 hours)

 

Issue was solved by setting
1. on all the 5 VSS hosts, omnirc variable "OB2VSS_TIMEOUT=2880
2. global variable on cell manager "CellResourceTimeout=86400


27 nodes could successfully be backed up up this way.

 

The 'omnirc' file does not exist by default, it can be created using Notepad and saved in the following location

 

            Program Data -> Omniback -> omnirc

 

When saving the file, make sure that it has no extension, like 'txt' or 'tmpl'. The Data Protector INET services must be stopped and restarted after creating or editing this file

 

The 'global' file is found on the cell manager:

 

              Program Data -> Omniback -> Config -> Server -> Options -> global

 

After making the edit, save the file, stop and restart Data Protector

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.