Command to perform DP upgrade in wondows (322 Views)
Reply
Occasional Contributor
hpfzail
Posts: 3
Registered: ‎02-25-2014
Message 1 of 3 (322 Views)
Accepted Solution

Command to perform DP upgrade in wondows

hi,

anyone know what is the command to perform DP upgrade in Windows. 

i use ob2install in unix/linux inviroment, but is there one for windows?

 

Thank in advance.

Honored Contributor
Sebastian.Koehler
Posts: 1,157
Registered: ‎02-27-2007
Message 2 of 3 (289 Views)

Re: Command to perform DP upgrade in wondows

Good news, ob2install also supports Windows platforms. You can run ob2install from UNIX/Linux CM to install/upgrade Windows clients. I've just discovered a documentation bug for ob2install, because the parameter list was changed. With the latest versions you might need to add an additional qualifier to your -input file.

 

Regards,

Sebastian

---
Assign a kudo to this post, if you find it useful.
HP Expert
Bob_Clark
Posts: 1,499
Registered: ‎08-14-2013
Message 3 of 3 (287 Views)

Re: Command to perform DP upgrade in wondows

It is a matter of downloaded the Installation bits to your Windows Installation server, or to a stand-alone system, and running the 'setup' command.  You didn't specify from what version to what version you want to upgrade, so, as an example, here is a link to the DP 7 Installation and Licensing Guide

 

http://support.openview.hp.com/selfsolve/document/KM1363249?searchIdentifier=6deae444%3a14689899366%...=

 

Upgrade steps are in Chapter 4, and, specifically for Windows, pp 165-168

 

 

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.