Re: Block size does not match this device - DP 7.01 (11478 Views)
Reply
Frequent Advisor
Stefano Colombo
Posts: 122
Registered: ‎11-14-2002
Message 1 of 3 (11,491 Views)
Accepted Solution

Block size does not match this device - DP 7.01

I'm configuring a copy job from Disk to LTO.

When running it I got the following message

 

Warning]

From: BMA-NET@srvbck.xxx.xx  "Drive0" Time: 14/06/2013 09:36:33

Block size of RMA-NET@srvbck.xxx.xxx (16Kb)

does not match this device (512Kb).

Blocks will be repackaged. Performance degradation may occur.

 

where should I configure the blocksize to match LTO's 512kb ?

thanks

Stefano

 

 

 

Please use plain text.
Valued Contributor
Ing. Bernd Riegler
Posts: 38
Registered: ‎01-21-2008
Message 2 of 3 (11,478 Views)

Re: Block size does not match this device - DP 7.01

The Block size of your disk has to be set to 512k in your RAID configuration.

Please use plain text.
Frequent Advisor
Stefano Colombo
Posts: 122
Registered: ‎11-14-2002
Message 3 of 3 (11,471 Views)

Re: Block size does not match this device - DP 7.01

Right , thanks for the point

Stefano

 

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation