8810 can't configure link-aggregation (238 Views)
Reply
Occasional Advisor
LostedMan
Posts: 10
Registered: ‎03-03-2011
Message 1 of 3 (238 Views)

8810 can't configure link-aggregation

[ Edited ]

Hi all.  Working late to build a 3com 5500G-EI XRN cluster, and that part has gone flawlessly.  Link aggregation is configured on that, but I'm hitting a snag with the upstream 8810 switch.  I've done:

Link-aggregation group 1 mode static [or manual]

Interface gig1/1/1                          [a ten-gigabit interface, but it's labeled as "gigabit"]

port link-aggregation group 1

 

and

Link-aggregation group 1

link-aggregation gigabit 1/1/1 to gigabit 1/1/2 both

 

and

Interface gig1/1/1

lacp enable                  [I don't want this but I tried it just to see what happened]

 

All generate the same error message: "4x10GE port cannot join link-aggregation group."

 

Background:

8810 running 3.01.31r

and the blade I'm trying is a 3C17526 4x10GE XFP-optic blade.

 

Help!

Any ideas?

Trusted Contributor
manuel.bitzi
Posts: 245
Registered: ‎10-19-2009
Message 2 of 3 (189 Views)

Re: 8810 can't configure link-aggregation

I remember that some blades of the 8800 had limitations with link-aggregation. I looks like you run into a such limitation.

 

But I found nothing about this blade in my archive.

 

 

Best Regards,

Manuel

H3CSE, MASE Network Infrastructure [2011], Switzerland
Occasional Advisor
LostedMan
Posts: 10
Registered: ‎03-03-2011
Message 3 of 3 (182 Views)

Re: 8810 can't configure link-aggregation

Is there any chance that updating the firmware would fix the problem?
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.