Swapping Instances in HPCA (399 Views)
Occasional Advisor
Posts: 13
Registered: ‎08-27-2013
Message 1 of 2 (399 Views)

Swapping Instances in HPCA

Hi,  I’ll try to explain this the best I can. I have to update a msi that is currently in HPCA .  It’s a very simple update just replacing a couple of files.  My concern is it’s currently installed on 500 computers and I don’t want HPCA to uninstall the current msi and then install the new one with the updated files.  It’s a pretty large msi. Is there a way to swap out the old HPCA job with the new updated one without having the old job uninstall itself and ultimately recognizing the updated files?  Thanks for any help in advance.    

Trusted Contributor
Posts: 156
Registered: ‎03-04-2010
Message 2 of 2 (367 Views)

Re: Swapping Instances in HPCA

[ Edited ]


You can try publishing those 2 files only using component select mode in publisher and then deploying them as a service on the target devices.


Agent does not necessarily uninstall the MSI and then re-install . It runs the command line specified in ZCREATE, ZUPDATE, ZREPAIR, etc based on the state of the software on the client. The administrator specifies the command while publishing. It can be modified using CSDB editor later also.


NO action will be performed if the command line is blank.



The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.