NNMi - UD integration approach (87 Views)
Reply
Honored Contributor
parkar
Posts: 2,306
Registered: ‎01-23-2010
Message 1 of 2 (87 Views)

NNMi - UD integration approach

Hello.

 

We are working on UD 10.10 on Windows platform with CP13 We have done UD-NNM integration but unable to get layer 2 connectivity with servers. NNM TOPOLOGY had been pull in UD but layer2 connectivity within network devices are exist but no layer2 connections with servers. NNM is monitoring only Network devices and Servers have been discovered from UD. Post integration, looking for the switch to server connectivity. But no such dependancies are exist.

 

How the solution works if I need layer2 connections with servers.

 

Do I need to map servers in NNMi ?

Cheers!

Nvr Blame a day in ur life....... Good day gives "happiness" & Bad day gives "experience" ......
HP Expert
Dima Gomel
Posts: 914
Registered: ‎03-09-2010
Message 2 of 2 (70 Views)

Re: NNMi - UD integration approach

[ Edited ]

Just to be sure that you are looking in correct place.  :)

In UCMDB Layer 2 is represented as CI connected to interfaces. So the view will be

switch -> interface <-L2-> interface <- server.

 

Hope this helps.

Regards
-Dima, HP Support
If you find that this or any post resolves your issue, please be sure to mark it as an accepted solution.
Click the Like button at bottom to say 'Thanks'
I'll be happy to be in touch at LinkedIn .
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.