Failed to Post Simple Key (266 Views)
Occasional Advisor
Posts: 11
Registered: ‎10-10-2013
Message 1 of 2 (266 Views)

Failed to Post Simple Key

When a component is modified, say added an input parameter.

When trying to enter data for that component in BPT flow (under Test Plan in ALM), I get an error as ‘Failed to Post Simple Key’ in ALM


How can this be resolved? I had to remove that component from the BPT flow and call it again. I lose the I/O mapping references everytime.



Frequent Advisor
Posts: 61
Registered: ‎02-04-2012
Message 2 of 2 (86 Views)

Re: Failed to Post Simple Key

Delete all the locks which are related to that instance (get node ID based on node id - delete all locks). and re try adding parameters.

hope this should help!!!

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.