HP ProDesk 600 G1 - unable to boot with USB (3294 Views)
Reply
Occasional Visitor
Drummer
Posts: 2
Registered: ‎01-18-2014
Message 1 of 4 (3,294 Views)
Accepted Solution

HP ProDesk 600 G1 - unable to boot with USB

Hello,

 

I received a new HP ProDesk 600 G1 yesterday and haven't had any luck getting it to boot to an USB flash drive or external USB hard drive.  I normally install our corp image (Win 7x64 Enterprise) via USB.  In setup the USB flash and USB HD are detected, but no matter what I set in the boot order when selecting F9 for boot options the USB device is not available.


 

Suggestions?

 

Thank you....

Occasional Visitor
Drummer
Posts: 2
Registered: ‎01-18-2014
Message 2 of 4 (3,288 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Problem solved.  In the Bios under Secure Boot Configuration - Legacy Support, i changed to Enabled.

For Secure Boot I changed this to Disabled.

Occasional Visitor
ndelbuon
Posts: 2
Registered: 4 weeks ago
Message 3 of 4 (334 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Is there something more?? It still will not boot. Even after I hit F9 and I get the boot menu, I choose legacy and none of the choices will allow me to press enter..

Occasional Visitor
ndelbuon
Posts: 2
Registered: 4 weeks ago
Message 4 of 4 (330 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Got it. The second part is to go back into setup. Go to Storage, Boot Order, then choose F5 to disable UEFI Boot Sources.

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.