Re: PCLXL error after firmware update (83 Views)
Reply
Trusted Contributor
Sys Admin
Posts: 332
Registered: ‎07-02-2002
Message 1 of 3 (83 Views)

PCLXL error after firmware update

Just loaded this new firmware for the 4250TN series:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18...
it is listed as fixing several issues on our 4250TN series, and our users are getting the following error now:
PCL XL error
Subsystem: GEDI
Error: InsufficientMemory
Operator: ReadImage
Position: 56

We are also using the recently released PCL6 drivers for this printer, which worked fine up until this firmware:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=18...

Any ideas? Or should I revert to the old firmware?
Honored Contributor
David Zuts
Posts: 3,878
Registered: ‎03-04-2007
Message 2 of 3 (83 Views)

Re: PCLXL error after firmware update

If you do not need pcl6, try using pcl5 or ps drivers as the error is only related to pcl6.
Trusted Contributor
Sys Admin
Posts: 332
Registered: ‎07-02-2002
Message 3 of 3 (83 Views)

Re: PCLXL error after firmware update

I fixed it by resending the firmware file.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.