Re: 5200 dtn (207 Views)
Reply
Occasional Visitor
Posts: 1
Registered: ‎02-15-2011
Message 1 of 2 (207 Views)

5200 dtn

After an update with the latest firmware via USB I get "resend update" message on the display. I then tried upgrading via the parallel port, it seems to work but the same message reappears. In the printed configuration I see the latest version (08.130.2), but for the jetdirect card (unused and apparently disabled) I get "INCOMPLETE F/W - MUST DOWNLOAD".
How can I solve the problem or really desactivate the builtin network card ?
Highlighted
Honored Contributor
Posts: 379
Registered: ‎09-30-2002
Message 2 of 2 (207 Views)

Re: 5200 dtn

Ian,

I might retry the F/W update. If not, I'd try a cold reset. Am assuming you have the embedded EIO (not a JetDirect Card). A cold reset should clear the EIO and then you can try to DISABLE it if its not being used.

Good luck.
"Everytime you do a good deed, you kick the devil in the butt." Tim Allen
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.