Re: LoadRunner/MI istener Best Practices (533 Views)
Valued Contributor
Posts: 274
Registered: ‎12-13-2012
Message 1 of 2 (575 Views)

LoadRunner/MI istener Best Practices



Are there HP documents on LoadRunner/MI Listener topology and Best Practices?



We are preparing to run a performance test in which we have Load Generators installed at customer's networks. Load Generators inside each network share the same external IP so we thought it would be best to use port forwarding. However only one Load Gen at a time can be reached / network with this approach.

Question: Is there a better way to set this up so that we could reach all of the load gens? Would adding an MI Listener server between the Controller and Load Generators help?


HP Expert
Posts: 18
Registered: ‎04-11-2001
Message 2 of 2 (533 Views)

Re: LoadRunner/MI istener Best Practices



Install an MI Listener and then use the "Run Over Firewall" configuration. This should  solve the problem. as it would allow all the Load Generator communication from/to the LR Controller to be proxied through the MI Listener. The Agent Configuration on each Load Generator must then be configured to run over firewall, and point to the IP address of the MI Listener machine.


For more information refer to the LoadRunner Controller User Guide > Working with Firewalls. This manual is available on the LR Controller machine in All Programs > HP LoadRunner > Documentation > Controller User Guide

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.