HP Autobackup PC100 configure (893 Views)
Occasional Visitor
Posts: 1
Registered: ‎09-30-2004
Message 1 of 3 (893 Views)

HP Autobackup PC100 configure

HP Autobackup PC100
PN: C7446A
ON Autobackup failured Primary HDD,crashed OS and it Doesn´t run. 1st NTFS partition-POSSP- Error:NT couldn´t start following file is missing:\winnt\system32\config\SystemHardwareProfile\Last Known Good Menu. 2nd NTFS part.-EOSPP- when go boot- freeze.
After failure HDD,was both HD drives replaced. Than system was autorebuild 100% and STOP with orange LEDs :Capacity License Violation.(Maybe 1 of disks failed ?).I cloned new Primary drive to good one of 2 old drives and replace secondary drive.Then System rebuild again and finish with message: "Setting lost,Reinstall system. In Manual-Administr.Guide- is stated: The error will be removed when the unit is rebooted during configuration of the IP address phase... So, now I can´t Access with admin web-based console to Run instal agent on some Backup PC and configure Appliance. I type IP adress from this manual: or , or . (From PC peer to peer w. cross cable and from any PC in our company LAN, too).LEDs in all LAN cards lights normally-activity. . Is some better IP adress or command for connect with autobackup via web-based console? Or Rebuilded sw in Autobackup maybe failed again? Exist some software,which can reinstall the whole Autobackup PC100? What can I do ,now? Many Thank
Occasional Contributor
Posts: 4
Registered: ‎09-16-2005
Message 2 of 3 (893 Views)

Re: HP Autobackup PC100 configure

Hi Silvar,

I have the same problem. After the dammage of the harddisc I search for solution to reinstall the whole AutoBackup PC100.

Have you found a solution?

Frequent Advisor
Posts: 41
Registered: ‎03-31-2003
Message 3 of 3 (893 Views)

Re: HP Autobackup PC100 configure

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.