Sitescope - show message in snmp trap (656 Views)
Reply
Occasional Advisor
YongGe
Posts: 12
Registered: ‎05-05-2010
Message 1 of 9 (656 Views)
Accepted Solution

Sitescope - show message in snmp trap

Hi,

 

I want to show detail message of snmp trap in Sitescope. But it only shown something about matchs. How could I do for this?

 

Thanks a lot,

Robin

Esteemed Contributor
Sergey  Popov
Posts: 295
Registered: ‎03-10-2010
Message 2 of 9 (649 Views)

Re: Sitescope - show message in snmp trap

Hi, Robin.

 

Try setting /.*/ in that "Match string" textfield.

 

Thank you.

Sergey.

_______________
This thread is now 20% cooler
Occasional Advisor
YongGe
Posts: 12
Registered: ‎05-05-2010
Message 3 of 9 (643 Views)

Re: Sitescope - show message in snmp trap

Hi Sergey,
It's the same, just show xx matches.
Thanks a lot,

Robin

HP Expert
Dmitry Shevchenko
Posts: 4,853
Registered: ‎01-30-2008
Message 4 of 9 (641 Views)

Re: Sitescope - show message in snmp trap

It should be /(.*)/

Occasional Advisor
YongGe
Posts: 12
Registered: ‎05-05-2010
Message 5 of 9 (633 Views)

Re: Sitescope - show message in snmp trap

It's no use. it seems diffcult to add the message in result and alert.

Occasional Advisor
YongGe
Posts: 12
Registered: ‎05-05-2010
Message 6 of 9 (621 Views)

Re: Sitescope - show message in snmp trap

add
---------------------- Description ----------------------

<secondaryStateProperties>

in alert template

Then it's OK
Advisor
Hanmu
Posts: 18
Registered: ‎06-27-2011
Message 7 of 9 (612 Views)

Re: Sitescope - show message in snmp trap

Hi,

Can you tell in which alert template do we need to add this description, and how..plz reply asap,I need this for one ongoing issue.

Regards,
Hanmu
Occasional Advisor
YongGe
Posts: 12
Registered: ‎05-05-2010
Message 8 of 9 (608 Views)

Re: Sitescope - show message in snmp trap

Hi Hanmu,

 

If you send an Email when an Alert happen, just create a new template in folder "\SiteScope\templates.mail"

 

Here's the template I use. You could create own one.

 

This alert is from SiteScope at <newSiteScopeURL>

Monitor:  <groupID>:<name>
Group:    <group>
Status:   <state>
Sample #: <sample>
Time:     <time>

The thresholds in <category> are:
<errorOnly>
<warningOnly>
<goodOnly>


----------------------   Description   ----------------------

<secondaryStateProperties>

 

Hope this could give you some help.

 

BR,

Robin

Occasional Advisor
snateam
Posts: 7
Registered: ‎03-15-2013
Message 9 of 9 (402 Views)

Re: Sitescope - show message in snmp trap

Dear All,

 

i had setup the snmptrap monitor, but never finding the /logs/snmptrap.log

 

Any setting is missing ?

 

Any idea help me to check it , Thanks

The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.