HP SiteScope - Changing the maintenance window to regenerate a new report (141 Views)
Reply
Valued Contributor
RYU123
Posts: 346
Registered: ‎10-09-2012
Message 1 of 2 (141 Views)
Accepted Solution

HP SiteScope - Changing the maintenance window to regenerate a new report

Dear Experts,

We are currently using SiteScope 11.22 installed on RHEL.

For the past few weeks we accidentally put the wrong maintenance window, therefore, it has affected the uptime for the weekly report we produce every week.

 

Is it possible to incorporate the new maintenance window and regenerate a report that incorporates the new maintenance window to get the uptime?

 

Any advice on this is very much appreciated.

Thanks,

Please use plain text.
Valued Contributor
RYU123
Posts: 346
Registered: ‎10-09-2012
Message 2 of 2 (119 Views)

Re: HP SiteScope - Changing the maintenance window to regenerate a new report

Ok nevermind, I have found what i was looking for.

So basically I generated a report that would ignore the new maintenance window even though the maintenance window was not applied to that monitor for the past few weeks.

However, generated a report that would ignore the new maintenance window which can be selected in the drop down menu when generating a quick report.

Thanks,

Please use plain text.
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation