Re: BSM9: Patches for Distributed Environment question (183 Views)
Reply
Valued Contributor
TEX2020
Posts: 377
Registered: ‎02-02-2011
Message 1 of 4 (222 Views)

BSM9: Patches for Distributed Environment question

If I have a Distributed Environment with two DPS and 2 GWs, do I need to isntall the BSM9 patches (9.13) on these ?

 

The are not full BSM 9 isntalaltions, only DPS adn GW installs only.

 

I have foudn that isntalling these patches with services down on the DPS and GWs that when bringing back up it fials and also Configuration Wizard fails.

 

Any ideas on this?

 

Thanks.

Tex2020
HP Expert
Dmitry Shevchenko
Posts: 4,882
Registered: ‎01-30-2008
Message 2 of 4 (215 Views)

Re: BSM9: Patches for Distributed Environment question

If patch installation instructions say to install the patch on both GW and DPS, that means the patch MUST be installed on ALL GW and DPS servers you have in your BSM deployment regardless of how many GW/DPS servers you have.

Valued Contributor
Ashok_I
Posts: 123
Registered: ‎06-13-2012
Message 3 of 4 (183 Views)

Re: BSM9: Patches for Distributed Environment question

Hi TEX,

 

Yes, you should intall this patch(9.13) on all the servers(DPs & GWs).

 

I too have distributed Environment, with 2 GWs & 1 DPS. I had BSM 9.12 earlier and now installed 9.13 patch on this.

 

I didn't face any failures while bringing them back.

 

Regards,

Ashok 

Trusted Contributor
patre_abhijeet
Posts: 226
Registered: ‎01-18-2012
Message 4 of 4 (175 Views)

Re: BSM9: Patches for Distributed Environment question

Dear Ashok,

 

You need to install service pack 9.13 on all the servers in your enviornment. There perform connect to DB from each server and then start the services starting from Primary DPS followed by gateway servers,

 

Thanks !

Regards,

Abhijeet
The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.